How it's made:

* 100% Hand Laid Using Grade A Epoxy Resin.
* 3K 2x2 Twill Weave Carbon Fiber Fabric or Carbon Kevlar Hybrid Fabric.
* Clear Coated. Achieving a Super Glossy Finish & UV Resistant. Why We Use Clear Coat Instead Of Gel Coat. Gel Coat is Dull. It Will Shrink, Crack & Fade. Clear Coat Will Hold-Up Much Better in The Long Run.

Installation:

* Designed For a Precise Fit Over Your Original Gas Lid.
* Clean Your Gas Lid Thoroughly with Rubbing Alcohol or Warm Water(3M Will Not Stick to Dusty Area). Peel Off Back Strips Of 3M, Align & Affix.

* Important Info *: According To Our Research, There Might Be A Few Different Armrest Lid Version For These Models. Please Compare Pictures To Make Sure Your Lid Measurement is Approximately Similar Before Purchasing. Check Out Our Other Listings For The Other Version.

Description:
* CFAC Real Carbon Fiber Armrest Lid Cover.
Fits: 97 - 03 Ford F150
97 - 02 Ford Expedition
97 - 02 Lincoln Navigator
* Available in: Black(regular) Carbon Fiber. Carbon Kevlar Hybrid: Orange/Green/Blue/Red.
* Fabric Info: Please Note That When Resin Are Applied to (Carbon Kevlar Hybrid Fabrics), it will typically slightly darken the appearance of the colors.

How it's made:

* 100% Hand Laid Using Grade A Epoxy Resin.
* 3K 2x2 Twill Weave Carbon Fiber Fabric or Carbon Kevlar Hybrid Fabric.
* Clear Coated. Achieving a Super Glossy Finish & UV Resistant. Why We Use Clear Coat Instead Of Gel Coat. Gel Coat is Dull. It Will Shrink, Crack & Fade. Clear Coat Will Hold-Up Much Better in The Long Run.

Installation:

* Designed for a Tight Fit Over/On Top Of Your Original Armrest Lid.

How it's made:

* 100% Hand Laid Using Grade A Epoxy Resin.
* 3K 2x2 Twill Weave Carbon Fiber Fabric or Carbon Kevlar Hybrid Fabric.
* Clear Coated. Achieving a Super Glossy Finish & UV Resistant. Why We Use Clear Coat Instead Of Gel Coat. Gel Coat is Dull. It Will Shrink, Crack & Fade. Clear Coat Will Hold-Up Much Better in The Long Run.

Installation:

* Designed For a Precise Fit Over Your Original Glove Box.
* Clean Your Glove Box Door Thoroughly with Rubbing Alcohol or Warm Water(3M Will Not Stick to Dusty Area). Peel Off Back Strips Of 3M, Align & Affix.